Linksys Switch Password Recovery Procedure
Originally authored by Jesse Molina,Have a Linksys SRW224G4 switch that was recently flashed with an upgraded firmware program, fesm-12216.ros. Connect the Linksys serial cable that came with the switch between the switch serial port and a nearby computer serial port. For Windows, use Hyper Terminal or VanDyke CRT/SecureCRT. For Linux, use minicom. 1.) Connect the Linksys serial cable that came with the switch between the switch serial port and a nearby computer serial port. For Windows, use Hyper Terminal or VanDyke CRT/SecureCRT. For Linux, use minicom. For other unix types, try cu/tip.
Revision History How to upload voice memos to google drive.
![Serial Serial](https://storefeederimages.blob.core.windows.net/clarioncommunicationsystems/Products/56882814-b975-49a8-b369-9690f79f2be8/Full/huuzvgvnbnj.jpg)
- 20060616, v1, Original document
Follow these steps to password recover the applicable Linksys switches.
Physical access of the switch is required, in order to connect the serial cable.
Linksys Srw224g4 Serial Cable Diagram
![Serial Serial](https://usermanual.wiki/Linksys/LinksysNullSrw224G4UsersManual657759.238098490-User-Guide-Page-1.png)
- 20060616, v1, Original document
Follow these steps to password recover the applicable Linksys switches.
Physical access of the switch is required, in order to connect the serial cable.
Linksys Srw224g4 Serial Cable Diagram
Kenworth navplus manual. This procedure applies to Linksys models SRW2016, SRW2024, SRW2048, SRW224G4, SRW248G4, and possibly other switches.
Linksys Srw224g4 Serial Cables Diagram
- Connect the Linksys serial cable that came with the switch between the switch serial port and a nearby computer serial port. For Windows, use Hyper Terminal or VanDyke CRT/SecureCRT. For Linux, use minicom. For other unix types, try cu/tip.
- The switch default serial port configuration is set to 38400 baud, 8 data bits, no parity, 1 stop bit, no flow control.
- Confirm that you have a valid serial connection by pressing enter a few times. You should be prompted with a login screen.
- If you have successfully established serial communication with the switch, reboot the switch by disconnecting and then reconnecting it's power cable.
- The switch will begin it's POST procedure as displayed in the serial terminal emulator. Be ready at the keyboard to press the Esc key.
- Watch for the following line to appear during the boot sequence. When you see it, immediately press the Esc key:IMPORTANT: Do not hold down the Esc or Enter/Return key during the boot sequence. Only press the Esc key when prompted.
- If you successfully interrupted the boot sequence, you will be prompted with a Startup Menu. Option number 3 will be the 'Password Recovery Procedure'. Select this option.
- The terminal will display, 'Current password will be ignored!'. Press enter to continue with the boot sequence.
- The default account 'admin/' will be enabled and you can log into the switch using this account. From here, you can set new accounts without having lost the switch configuration.
- After you have configured new accounts and documented the passwords, reboot the switch and log in normally to confirm that passwords have been recovered successfully.
- You are done. Disconnect and store the serial cable in a safe place for future use. Be sure to document a login username and password somewhere safe for future reference.